Fixing the shower room glass method shower room tells you a small coup

Fixing the shower room glass method The shower room tells you a small coup. With the continuous improvement of living standards, everyone's requirements for the quality of the home environment are getting higher and higher. As an important area for bathing, the shower room, whether it is the choice of materials or the overall layout design, is very important, because it determines the safety and comfort of bathing. In the bathroom of home decoration, the separation of dry and wet is already the conventional layout of most home decorations. The design of such separation of dry and wet is not only from the point of cleanliness, safety and hygiene, it is also a design that is worthy of promotion. Therefore, installing a glass shower room is already a very common way of decoration. Someone asked how to fix the glass in the shower room to the wall? Let me give you a brief introduction to the glass installation problem in the shower room, I hope it will be helpful to you. Fixing the glass method 1. Alloy or stainless steel edging is a common practice in ordinary home decoration. The glass is wrapped with an alloy or stainless steel frame, and then the frame is fixed to the wall. 2. When fixing the hardware during installation, clamp the glass with a glass clamp, fix the glass and the hardware through the hardware, and then install and fix the hardware to the wall. This method requires hardware fittings to be fixed to the wall during installation. After installation, there will be a certain distance between the glass and the wall, which will make the sealing of the shower room not good. If the sealing of the shower room is pursued , Just look at the ① or ③ plan. 3. The glass glue is used to install and fix the glass with glass glue. It is usually combined with hard installation. In the early construction, the groove inlaid with the glass is reserved. After the glass is placed, the glass glue is fixed. Usually, about the glass shower room The installation must be done before the bathroom tile is common, and the installation method should be determined with the manufacturer, and then let the tile master reserve the location for the installation of the shower room. Do not paste the floor and brick tiles, and then look at the glass shower. Room, in this case, the choice is very passive. (