How to install the entire bathroom? Precautions for overall bathroom decoration?

How to install the entire bathroom? Precautions for overall bathroom decoration? How to install the entire bathroom? Now people will design the entire bathroom when decorating and designing the bathroom. The entire bathroom is not only beautiful, but also easy to use and comfortable to use. But the entire bathroom needs to be installed and designed. Only after installation can it be better used. When decorating, the entire bathroom also needs to be properly designed. The following is a series of small common sense introduction items focusing on the overall knowledge of bathroom decoration. How to install the whole bathroom? 1. Ventilation: The whole bathroom is damp when taking a shower. Ventilators generally have two gears. The high-grade ones can quickly remove the water vapor in the bathroom, and the low-grade ones are mainly used to remove the peculiar smell of the bathroom. When choosing a ventilator, the most important thing is to look at the noise of the motor. General motors are oil bearings, which belong to sliding friction, which will generate louder noise and will resonate with the ceiling. 2. Check the installation: first turn on the switch of the corresponding equipment for the heating of the entire bathroom. The lamp heating test needs to be turned on for 15 seconds. If there is heat, it proves that there is no problem. After the air heater is turned on, you need to feel whether there is hot air at 1.8-2m from the air heater. If there is, it means that the wind heating is normal. Precautions for overall bathroom decoration? 1. Threshold design. The entire bathroom threshold design is very important, because it can prevent the overall internal bathroom water from flowing out, so the threshold decoration design should pay special attention to the threshold graphic design must be inclined to the bathroom inside, which is conducive to drainage, and the water cannot penetrate Outside. The second thing we need to pay attention to is that the width of the threshold must be the same as the width of the door frame, and the thickness of the threshold must also be the same as the thickness of the wall to reduce the probability of default when laying the floor. 2. Laying floor tiles. The laying of floor tiles in the bathroom requires attention to several aspects. The first thing to note is that the floor tiles cannot be laid, because the water in the bathroom has to flow to the drain. The paving of the floor tiles needs to be slightly inclined so that the water can flow into the drain smoothly. The second thing to note is that the joints of the floor tiles must be the same, and they must be aligned with the joints of the wall tiles. 3. The floor is waterproof. Ground waterproofing is also a very important thing, and the most common waterproofing material is waterproofing agent. When decorating the bathroom, the waterproof layer must be spread 20 cm above the ground, and the minimum height cannot be lower than the threshold. If there are reserved pipes on the ground, they need to be wrapped with waterproof layer. 4. The socket in the entire bathroom should be waterproof. The toilet socket should be sufficient, otherwise there will be more problems in the future. If there is a socket next to the wash basin, you can put a hair dryer. If you want to install a smart toilet, you should reserve a socket next to the toilet. In addition, for safety, it is best to use a waterproof socket with a cover. If these things are not well decorated in the early stage, the ** board can only be used in the later stage. It is unwise to do this in a humid bathroom. (