Bathtub installation detailed guide, easy to get three steps and two injections

The installation of the bathtub is usually a big problem in the bathroom decoration, because the bathtub is a large part of the bathroom, a little carelessness will cause a lot of trouble in the later period, so we must pay special attention to the installation method of the bathtub. Apart from paying special attention to waterproofing, the installation method of the bathtub has more details that cannot be underestimated. Today, let's take a look at the installation method of the related bathtub.

1. Frame description: dig a 150mmx305mm hole at the ground 340mm for drainage positioning.

2. Accessories installation: according to the manufacturer's instructions, install the overflow pipe part and the drain pipe part.

Note: Users can install horizontal drainage or vertical drainage according to their needs. After swinging the drainage tee 90 degrees in the direction of the arrow, turn it 180 degrees on the plane to form a horizontal drainage type.

3. Installation instructions: Put the bathtub in the groove, check whether the level, front and rear, left and right positions are appropriate, and check whether the floor drain holes are appropriate. The bottom of the bathtub skirt should be close to the smooth tiled floor and hold the bathtub just right.

Note: The brick wall support should be stable. When installing the bathtub, the bottom of the bathtub should be close to the fine sand, and the bottom of the bathtub should not be supported by bricks to avoid damage to the glaze during use.

Check whether the level, front and rear, and left and right positions are appropriate, check whether the drainage facilities are appropriate, and install them firmly. During the installation process, take anti-dirty, anti-collision and anti-clogging facilities for the bathtub and drainage facilities, angle grinders , Do not splash the spark from the spot welder on the bathtub, otherwise it will damage the glaze and affect the beauty of the bathtub.