Classification and use of different bathtub toilet maintenance cleaners

Tools: brushes, sponges, neutral cleaning agents

Key: the water-stop rubber should also be cleaned

The toilet can be cleaned with brushes or sponges on the market. Wash with neutral detergent and cold or warm water. When cleaning, pay special attention to the edge of the water circle and the drain under the water seal, because these two places are the most easy to hide dirt and dirt in the toilet. When the toilet lid is dirty, wipe it with a cloth dipped in a neutral detergent. Never use gasoline, pine perfume volatile liquid, acid solvent or hot water to wipe the toilet lid. Another method is to use vinegar instead of neutral detergent, and then wipe the flushing water, and repeat this several times.

For the water stop rubber of the toilet inlet valve, it is easy to age and fail in the place where the water quality is not good, so it must be taken out and cleaned frequently.

Smart sanitary ware

Tools: special cleaner (non-corrosive), sponge (soft cloth is also available)

Key: electronic eyes should avoid washing with water

The 'value' of smart bathroom is much higher than that of ordinary bathroom, and the maintenance method is naturally more particular, which is not sloppy.

Before using the cleaning agent, be sure to try the product in an unobtrusive place and confirm that there is no bad damage before applying it to the entire product. After using the cleaning agent, immediately wipe the surface clean, and be sure not to leave the cleaning agent on the surface.

To clean the electronic eye, it is best to avoid washing with water to prevent unnecessary troubles such as wet water on the induction circuit board or short circuit of the circuit.

During the use of the product, if the product cannot be handled according to the instructions for use, you should contact the local agent or manufacturer for professional maintenance in time, and avoid accidental damage caused by your own claims.

Massage bathtub

Tools: granular cleaner

Key: Avoid using cleaners used on tiles or enamel surfaces, and do not allow cleaners to enter the circulatory system.

Use granular cleaners that can be mixed with water to clean the jacuzzi. Avoid cleaners used on tiles or enamel surfaces. Do not place the container of liquid detergent on the surface of the bathtub for a long time, and do not use spray or concentrate or other similar cleaning products. Don't let nail polish, nail polish remover water, dry liquid cleaner, acetone, paint remover or other solvents come into contact with the acrylic surface. The corrosive cleaning agent will cause damage if staying on the acrylic surface. Be careful to clean the acrylic surface thoroughly after each use, and do not let the cleaning agent enter the circulation system.

General Techniques

The cleaning of the bathroom must first be ventilated. When using the bathroom, turn on the ventilation fan, and when not using the bathroom, open the door of the bathroom. After bathing, open the ventilation fan and the door of the bathroom at the same time to expel water vapor more quickly. The bathroom that is not ventilated will cause condensation, damp walls, mildew, and black spots on the faucet. This is a very lazy way, everyone should try to follow these links as much as possible!