Dexidun Sanitary Ware will tell you why the toilet has two buttons!

Dexidun Sanitary Ware will tell you why the toilet has two buttons! Everyone uses the toilet every day. Have you noticed the two buttons on the toilet tank? I believe that many people did not know the difference between the two buttons before. They just press it casually when flushing. If the flush is not clean, press it again. However, in fact, there is a big difference between the two buttons above. The meaning of the size buttons: The two buttons of the toilet tank. Do you think these two buttons are designed to look good? In fact, this is a design to help you save water. These two buttons, one large and one small, respectively represent the function of full water and half water drainage. The small button is in a half-water state, when it is pressed, only half or one-third of the water in the water tank will be discharged. The big button is full of water. When it is pressed, it can release all the water stored in the water tank at one time. With greater water power, the flushing will be cleaner. Commonly used method: Two buttons of different sizes have different functions, and different button methods are used according to different situations, which is not only efficient, but also more water-saving. Because the small button has a low momentum, press and hold the small button lightly, which is suitable for flushing a small amount of urine; if you press and hold the small button, you can flush a larger amount of urine. For large buttons, lightly pressing the large button is suitable for a small amount of defecation; otherwise, you need to press and hold it for a long time. Pressing the two keys at the same time not only has the largest water volume, but also has the strongest scouring force. If the stool is sticky and not clean, you can choose this way. Note: After pressing the button, you need to make sure that the button rebounds~ If we release the button after pressing the toilet flush button, but the button does not rebound, then the toilet will be in a state of constant flushing, which is wasted There are a lot of water resources, so after flushing, everyone must make sure that the toilet flush button has rebounded to its original state, so that water will not be wasted in vain. How to improve the hydraulic adjustment of the toilet. Press the pressure lever of the toilet. After the toilet in many families has been used for a long time, it will be difficult to discharge the toilet and the flushing force is not enough. You think the toilet is aging, but you only need one trick to easily solve this problem. There are many reasons for the poor drainage of the toilet. One possibility is that the pressing lever on the top of the toilet is too low. This can be adjusted by yourself. Open the toilet sink and adjust the position of the pressure lever on the corresponding screw. This is because the principle of toilet flushing is to press the water tank according to the length of the pressing rod. If the pressure rod is too short, there will be insufficient pressure, resulting in insufficient hydraulic power. Another reason why the water power of the toilet is not enough to adjust the water inlet valve may be that the water level of the water inlet valve in the water tank is too low to cause the flushing power to be weak. Solving this problem is also very simple. Open the sink and remove the buckle on the inlet valve. After removing the buckle, turn the buckle counterclockwise to buckle the other end down to the position of the tray for a few more loops, so as to increase the pressure of the water inlet tray and increase the flushing force.