Different types of shower installation skills must be collected!

Different types of shower installation skills must be collected! There are always many trivial matters in house decoration that make people headaches. I wanted to solve the problem easily, but I couldn't start. The installation problems of showers in the bathroom are different. Today, I will share a lot of dry goods with you. As long as you master these skills, shower installation is no longer a problem, and you can easily play in the bathroom. 1. Surface-mounted shower 1. The height of the shower mixing valve from the ground: When installing the shower, you need to master the height of the shower mixing valve from the ground. The distance between the shower mixing valve and the ground is about 90~ About 100cm, of course, you can adjust it according to your height. Don't be higher than 110cm, so as not to install the shower riser. 2. The height of the shower faucet: the reserved wire head used to install the shower faucet should be just buried in the wall tiles. Just cover it with a decorative cover when installing, so as not to affect the appearance. Therefore, when laying sanitary pipes, you need to consider the reserved position of the wire head, which is generally 15mm higher than the rough wall to ensure the beautiful wall. 2. Concealed shower head 1. The connection between the main body and the pipe needs to use a joint for the transfer function, and the joint needs to be sealed with a raw material tape. 2. Place the product connected between the main body and the tube against the wall, and draw the outline with a pen to prepare for slotting. 3. The wall is drilled according to the size, and then grooved. 4. Put the green rubber particles into the wall and fasten the main body to the wall with screws. 5. Turn the handle and the water divider wheel on the product, then plug the thread of the water in and out with a plug, test the water normally, and there is no water leakage. If the water test is no problem, remove the handle wheel and handle. 6. Remember to put the protective cover back before attaching the tiles, and tighten the screws to prevent damage to the surface of the main body. 7. After the tiles are pasted, the handle, top spray, panel, decorative cover, and water divider can be installed. 3. Constant temperature shower 1. Before installing the constant temperature shower, you can turn on the water pipe switch, try to let the water flow to wash away the sand and pebbles in the water pipe, because the pebbles or sand will block the constant temperature shower, which will shorten the use of the shower. life. 2. When installing a thermostatic shower, pay attention to the location of the hot water source. The thermostatic shower itself does not produce hot water. It is mainly based on the hot water provided by the water heater and then keeps constant temperature. If the water heater is too far away from the shower faucet, it will decrease. The thermostatic function of the thermostatic shower. 3. The biggest advantage of installing a constant temperature water shower is that it can be kept constant in the case of unstable water pressure and sudden cold and sudden heat. Even so, the water pressure should not be too high or too low, so as to keep it at 0.05Mpa to 0.6Mpa. between. 4. Pay attention to the installation position of the hot and cold water supply pipes. Generally, the hot water pipe is on the left and the cold water pipe is on the right. This is an industry standard to ensure that the water supply pipes are unblocked. The installation of the shower head directly affects the later use experience, so everyone needs to pay more attention to the details and carry out detailed layout measurements to achieve the most ideal decoration effect. (