Installation of faucet

First prepare the installation tools, and check whether the supporting parts are complete before installation. Common faucet parts include hoses, rubber washers, showers, drains, crutches, decorative caps, etc.

1. Installation of single-hole basin faucet

When buying a single-handle basin faucet, you should pay attention to the diameter of the drain outlet. Most of the water in the market is hard pipe water inlet, so you should pay attention to it. Leave the height of the nozzle, 35 work points** from the basin downwards is appropriate. During installation, a special angle valve must be selected, and the angle valve must be fixed to the hot and cold water pipes out of the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak water, causing you loss. If the inlet pipe is too long to exceed the outlet pipe, the part can be cut off according to your needs. If the angle is not suitable, it can be bent to the position you need. Remember: Don't bend hard to 90 degrees or more than 90 degrees. When installing the basin to drain, please do not forget to purchase the small connector of the faucet (short-circuit the faucet). Please don't forget to flush the water pipes buried in the wall before you install it.

2. Installation of shower, bathtub faucet (wall-mounted)

After you purchase shower, bathtub, wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.

Concealed shower and bathtub faucets: After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be embedded. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores during pre-embedding. In addition, you should pay attention to the up and down, left and right directions of the spool when embedding the spool, so as not to embed the spool incorrectly. When the wall-mounted faucet is embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.

3. Installation of the thermostatic faucet

Before installing the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right. Remember not to connect the hot and cold water pipes incorrectly to prevent the faucet from failing. normal work. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don't forget to install the hot and cold water filter when installing the thermostatic faucet.

4. Installation of single-hole kitchen faucet

It is required to be stable, because the kitchen faucet is used frequently, and it is easy to loosen when being moved, so the locking nut must be Tighten. At present, there are some faucets on the market to fix the screw tube with enlarged nut. This kind of stabilization effect is very good. If the problem of water removal and lifting can be solved, it will be a popular trend in the future.