Rifeng bathroom bathroom decoration tips to share

Rifeng Bathroom Bathroom Decoration Tips Sharing We all know that the bathroom decoration is a very important part of our home improvement process. The quality of the bathroom decoration will greatly affect our future life. So I will share with you some tips on bathroom decoration. 1. If possible, the layout of the water and electricity pipelines should be as high as possible. If it is high, you can ask for the tiling to be higher, and the ceiling should be higher. It will appear that the bathroom space is much larger. In the red frame in the picture, it can actually be turned Post a bit on the Internet, and do it on the ceiling. 2. The access port of the sewer pipe must be tightened. You don't want to leave the yellow liquid upstairs in your house after the decoration is completed? In addition, if you have a supervisor's access port, it is recommended to keep it to avoid troublesome maintenance later. I have seen a lot of newly renovated houses, which are leaking due to the lack of tightening. 3. It is recommended to change the wall row when the basin is drained. In this way, the bathroom cabinet can be used as a wall cabinet, or with long legs, so that it can be stored underneath. However, when changing it, it should not be too long or bend too much, otherwise it will be easy to block in the future, and it will not be easy to dredge. 4. It is recommended to buy ultra-thin and fast down the floor drain, so as to avoid buying the wrong one. (Because the ultra-thin displacement can be used without displacement) 5. Floor drain displacement plumbers and masons should cooperate well, otherwise the slotting is shallow, the backfill is less, the floor drain is installed crookedly, and the anti-odor core may not be installed. Yes, you don’t want to open the bathroom door and the sourness of the sewers will come on you? Of course, the next word is more applicable. 6. Deodorization of the toilet: The installation of the toilet should be carried out in strict accordance with the requirements. For example, first flatten the drain pipe, then use putty to connect the round drain pipe with the floor tiles and smooth it, and then the flange is close to the ground. There will be no odor leakage. I guess you don’t know what I’m talking about. Of course, many toilets will not deodorize if they are installed casually. Why? Because the toilets are all closed, the closed barrels are directly covered. Go up, the odor will not escape after the glass glue is filled around, so pay attention to fill the glass glue, including the two holes on the back of the toilet that should have been screwed. However, if your toilet is leaky behind it, the junction between the toilet and the ground is not so easy to seal, then please install the toilet in accordance with the specifications, otherwise wait for the sourness. 7. After the PPR pipe is installed, the probability of water leakage is much less than the probability of water leakage at the interfaces during the later installation. For example, if the angle valve or any place where the raw material tape is used, if it is not suitable for the first installation, the raw material tape must be re-wrapped when reinstalling. After installation, check the interface for leakage. 8. The angle valve is actually not anxious to buy, you can wait until the bricks are pasted, because if the wall is not flat and the tiles are to be flat, you may need to buy an extended angle valve. 9. It is recommended to use the original film for the shower room. , No matter how awesome the toughened glass is, there is a possibility of self-destruction. 10. Please fill in all the joints, the junction of wall and floor tiles, the junction of floor tiles and threshold stones, the junction of floor tiles and water retaining strips, even if you plan to make joints in the future, including the junction of wall and floor tiles, threshold stones and ceramic tiles For the reason, see the next 11. The threshold stone of the bathroom should be wet-laid. According to the reason, all the floor tiles in the bathroom should be wet-laid. However, for the convenience of paving, the masons usually dry-laid. Then the problem is, dry-laid. Under the circumstances, there is a layer of cement sand dust layer below, then if there are any gaps, the water will flow down the various gaps, through the cement sand dust layer, flow to the waterproof layer to stay, if you happen to be under the threshold stone If the waterproof beam is not poured or the threshold stone is dry-laid, then congratulations, the water will flow out of the threshold stone and flow to the outside of the bathroom, such as various rooms with wooden floors, and then you will find that the wooden floor will be black and the door cover It will turn black, and there will be water stains at the corners.