Rifeng Sanitary Ware explains the reasons and solutions for the slow flushing speed of the toilet

Rifeng Sanitary Ware explains the reasons for the slow flushing speed of the toilet and the solution . If this happens in your own home, you can use a bucket to fetch water, but if you are in someone else's home, this is really a very embarrassing thing. So what is the reason for the slow flushing speed of the toilet? If we encounter this kind of thing, what should we solve? What are the solutions? Today I will give you a detailed introduction. Reason 1: The flange interface is not installed properly, and the water flow is reduced. Solution: 1. When buying a toilet: be sure to pay attention. Generally, the water pipe from the water tank to the tile is about 30~875px, and their diameter is 2750px. 2. When installing the toilet: it is necessary to supervise the whole process, and it is necessary to confirm that the installation location and method are not flawed, or if there is a problem, the whole must be disassembled and reinstalled. 3. After installing the toilet: do not test the water immediately. If the water is tested immediately, the cement at the bottom will be washed away, causing the toilet to be unstable and leaking from the bottom. Don't use it right away, because the bottom cement is not dry. Reason 2: The toilet itself has insufficient pumping power, and the water pressure is insufficient. Solution: 1. You can increase the water volume, such as putting a bottle in the water tank. 2. Adjust the screw of the inlet valve clockwise to increase the water level. Pay attention that the water should be at least 10mm away from the overflow pipe of the drain valve. 3. Properly adjust the water level of the water tank. The flushing is sluggish, and the flushing water is slow. It only means that the drain pipe is a bit blocked. You can dredge it. If the flow from the water tank to the toilet is slow, check whether there is something blocked from the toilet tank to the flushing outlet. NS. Reason three: Insufficient flushing water, water stoppage, etc. Solutions: 1. If the water is not enough, you can remove the water tank cover to adjust the water volume. There are two plastic rods under the toilet water button. There are cock on the top to adjust the length of the plastic rod to control the amount of water. 2. If it still doesn't work, you can only change the toilet, you can choose a siphonic toilet, the effect is good. Reason 4: The long-term use has caused the sewage pipe to be contaminated with dirt, which caused the sewage to become smaller. Solution: You can remove the sewage pipe and put it in the acid substance to eliminate the accumulated dirt, and then install it and drain it. It will be much faster. If a soft object is blocked, you can use a soft screw or use the toilet to kick it. If it is a hard object, it is best to find a professional company to solve it. Summary: It is embarrassing if the toilet dirt is not flushed. Once this kind of flushing problem occurs in the bathroom at home, it will always make people feel very upset. In fact, when the source is found, this problem can be avoided in many cases. This issue will be analyzed with you today, and the content is for your reference only. (