Why is the bathtub clogged and how to unblock the bathtub sewer

If the space in the home is sufficiently rich, I believe many owners will choose to install a bathtub in the bathroom. We can not only use the bathtub to take a bath, but also improve our quality of life while relaxing the mind and body. Let the editor take you to understand in detail why the bathtub is clogged, and point out some coup tricks for everyone to clear the bathtub drain!

First, the main reasons for bathtub blockage:

1. Hair usually causes the toilet to block the floor drain, wash basin plug, bathtub plug, and shower block. Therefore, a cover is usually used for drainage cover and other protective equipment to a certain extent, if hair can be easily picked up in the trash can and thrown away.

2. It is very common to block the sewer with a hard object, and accidentally sink into the hard object to block the drainage without using it. zhuangshi5.cn

3. Sewer blockage caused by decoration. This is the most likely occurrence of furniture, we have encountered a lot, because when you are not careful, the case is refurbished due to the blockage of the sewer, this is definitely not a coincidence, so we must take protective measures before accessories.

Second, how to unblock the bathtub drain:

1. Because there is a cover at the drain in the bathtub, it can only be unblocked from the floor drain. Buy a hand-cranked spiral wire from the floor drain Push it down while shaking until it feels like a foreign object, and then gently pull it up while shaking it. The clogged hair and other dirt will spin on the spiral steel wire, just take it out.

2, put the caustic soda into the mouth of the sewer, and then pour the boiling water in.

3. Thick rattan can be used. The head of the rattan can be nailed with ten and eight-inch long iron nails. The rattan is pushed in and pulled out, and it will be dredged if you operate it many times.

3. Other tips:

1. Animal oil blocking: If it is oily, it is recommended to use boiling water. Of course, if you can buy concentrated sulfuric acid, the effect will be better. If something is clogging, the only way to clean the pipeline is to use special tools.

2. Cement plugging: 70% hydrochloric acid is not found, 35% is sold everywhere, you can try it. Add a small amount of flour to it to act as a corrosion inhibitor, and urotropine is best. Can reduce the corrosion of steel.

3. Go to the market and spend ten quick dollars to buy a 2-meter-long spring steel pipe dredging tool, and make a 10-20 degree bend at 1-2 cm above its head. The entrance and exit are dredged back and forth, and flushed with water.

The above is the introduction brought by the editor. If you want to know more related knowledge, please continue to pay attention to Qijia Consulting. Please stay tuned for more wonderful consultations.