What to do if the shower is leaking Zhongtao Sanitary Ware teaches you a simple method

What to do if the shower is leaking Zhongtao Sanitary Ware teaches you a simple way to solve the shower leaking, you still don’t know? There are many reasons for water leakage in the shower. In general, there are many reasons for water leakage at the connection between the nozzle and the handle and leakage at the steering ball of the nozzle. For the water leakage at the connection between the nozzle and the handle, we generally use: 1. Use the lashing pliers to unscrew the nozzle handle from the hose. If other wrenches are used, tape the hose to prevent it from being scratched. 2. Clean the threads on the handle, and apply plumber’s adhesive or plumber’s tape around the sides. 3. Turn the nozzle back and tighten it by hand. Remove all excess adhesive and tape. The leakage of the shower nozzle steering ball is generally used: 1. Unscrew the nozzle from the steering ball ring; 2. Find the O-ring inside (this ring can prevent water from leaking out) or similar seals. Replace it, and then rotate the nozzle back to its original position; 3. The problem of the nozzle may also be caused by sand or sediment in the nozzle, or accumulated dander and mineral deposits. 4. The solution is to unscrew the nozzle from the steering ball and then clean it. Shower installation 01. Pay attention to the height of the mixing valve. The height of the shower mixing valve from the ground. When installing the shower, the first thing we must determine is the height of the shower mixing valve from the ground. Generally, the shower is installed. Previously, we have already determined where to install the shower head. Then the distance between the shower mixing valve and the ground is generally controlled within the height range of about 90~100cm. In this interval, we can also fine-tune according to our height. But generally don't be higher than 110cm, if it is too high, it may cause the shower riser to be unable to install. 02. Reserved wire head The reserved wire head of the normally installed shower faucet is just buried in the wall tiles. It is best to just cover it with a decorative cover. Otherwise it will look unsightly. Therefore, it is best for everyone to consider carefully when laying pipelines. Generally, it is 15mm higher than the rough wall, so that the wire can be buried when the tiles are finished to ensure that the wall is beautiful. 03. The reserved spacing of the inner wire elbow of the shower head is generally about 10~15cm. Generally, when buying a shower, the seller will give two adapters, so that the water inlet of the mixing valve can be well connected to the hot and cold water outlet on the wall. However, as far as possible, do not use the adapter to transfer, so it is more beautiful. Precautions for the installation height of the shower head 1. When installing the shower head, you need to make holes, and you need to pay attention to not punching through the water pipes in the wall; 2. When installing the shower head on the round bottom cover, you must tighten the screws, otherwise It will cause the shower to fall off. 3. When installing the hand shower, it must not be robbed or twisted; 4. Before installing the shower, be sure to determine the installation height and make a mark. (