Don't ignore the details of the first-line brand bathroom bathroom design

Bathroom decoration is a very important item in home decoration, and it is also the most complicated and cumbersome decoration, especially the first-line brand bathroom decoration has many details that need attention. If these details are ignored, the comfort and safety of the bathroom will be greatly reduced, which will have a great impact on the quality of life at home in the future. Therefore, it is not an exaggeration to say that details determine success or failure, and perfection. Foshan Yingding Sanitary Ware, a first-line brand bathroom manufacturer tells you that there are several aspects of the construction details of bathroom decoration. Thresholds, waterproofing, floor tiles, circuits, walls, and floor drains are all key parts. These construction details can help better Realize the decoration effect. 1. Bathroom threshold construction skills Threshold is the first gateway of the bathroom, which plays a role in waterproofing and dividing space in the bathroom, and it also has the meaning of gathering wealth in Feng Shui. The key points of the construction design of the threshold are to pay attention to the slope of the upper surface of the threshold to the inside of the bathroom, so that the water can smoothly slide to the floor drain inside the bathroom. The second point of the threshold construction is to be the same width as the door frame, and the door frame must be the same thickness as the wall, so that the dimensions can be the same when laying floor tiles, which is very effective in preventing cracks. 2. Waterproof construction techniques for bathroom floors. At present, the main waterproof material used for floor waterproofing is waterproofing agent. When laying the first-line brand bathroom waterproof layer, it should be laid 20 cm above the wall foot, and the height of the waterproof layer cannot be lower than the height of the threshold. When pipelines are reserved for floor oil, the waterproof layer should keep the reserved pipes. After the waterproof layer is finished and dried, cement mortar should be used as a primer immediately to prevent damage to the waterproof layer. 3. The details of laying floor tiles. When laying floor tiles, pay attention to the thickness of the joints of the floor tiles and align them with the joints of the wall tiles; the floor tiles must have a drain slope. If a bathtub is installed in the bathroom, the front wall of the bathtub must be bricked and tiled. At this time, it is best to stick the floor tiles to the bottom of the wall first, and then stick the wall tiles to avoid cracks. 4. Bathroom circuit laying details The wire joints in the bathroom should be hung with tin, and should be wrapped with waterproof tape and insulating tape to ensure safety and prevent leakage. Therefore, the wire body must be covered with a flame-retardant tube, and the switch and socket should preferably have a moisture-proof box or be installed in a dry area. 5. The details of bathroom wall tiling. Before tiling, the wall should be moisture-proof and waterproof. When tiling, the wall should be flat, and it must be seamed and aligned with the floor tiles to ensure the integrity of the wall and the ground. 6. Construction details of bathroom floor drain Generally, the reserved holes for drainage of new houses are relatively large when the new house is handed over. This requires attention to repair the reserved holes for drainage to make it consistent with the floor drain purchased. In order to prevent hair, sludge, sand and other dirt from entering, the hole diameter of the refurbished floor drain grate should be controlled between 6-8mm. Yingding Sanitary Ware: first-line brand sanitary ware manufacturer, brand sanitary ware franchise agent in the national investment promotion. Official website: http://www.yintinwy.com/