The installation of hot and cold faucets is very important, otherwise the hot and cold water will not come out.

The faucets installed in newly renovated houses will definitely be hot and cold faucets, and some old houses will decide to replace them in order to have hot and cold faucets. For the hot and cold water faucet, the difference from the cold water faucet is that the installation will be more cumbersome. Let's take a look at the installation of the hot and cold water faucet!　　Installation of single-hole hot and cold basin faucet　　Install the single-hole hot and cold water faucet to reserve the height of the water pipe. It is best to reserve about 30㎝ from the basin first. Moreover, a special angle valve must be selected, which must be fixed to the hot and cold water pipes out of the wall. If there is a distance between the angle valve and the water pipe on the faucet, you need to purchase a special pipe to extend the connection. Do not use other water pipes to connect, otherwise it will leak or fall off due to high water pressure. If the inlet pipe is too long to exceed the outlet pipe, just cut off the excess part.　　Installation of hot and cold water faucets for showers and bathtubs　　To install such hot and cold water faucets, you need to choose a height of more than 20 cm to bury the water pipe. Special attention should be paid to flushing the water pipe before installation to avoid damaging the faucet due to hard water.　　 And if the home is a concealed shower and bathtub faucet, the valve core of the faucet must be buried in the wall. If the wall of the home is too thin, it cannot meet the installation conditions. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores during pre-embedding. In addition, you should pay attention to the up and down, left and right directions of the spool when embedding the spool to avoid the wrong spool.　　Single hole kitchen faucet faucet installation　　This kind of hot and cold water faucet installation requires special attention to the need for stability, so be sure to tighten the nut, and choose a good screw tube to stabilize the nut is the most important thing to pay attention to.　　Shoe-type hot and cold water faucet installation　　The first step: the hot and cold water pipes correspond to the water inlet of the hot and cold water faucet. Don't install this wrong.　　 Step 2: After the connection is completed, thread the fixed column of the faucet into the two inlet pipes to ensure that the heat and cold are correct.　　 Step 3: Install the assembled hot and cold water faucet on the sink, washbasin, etc., and put the water inlet pipe into an opening of the washbasin. Finally, the horseshoe piece of the faucet is fixed, and the screw nut is tightened.